Farmall & IHC Tractors Discussion Board |
Re: Farmall M now stuck
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Janicholson on July 07, 2005 at 18:29:37 from (66.173.50.66):
In Reply to: Farmall M now stuck posted by Tx sBoy on July 07, 2005 at 17:57:41:
Tx, I believe, but do not know, that the first issue (stuck in 5th) was due to a worn tip on the shifter lever. There are several posts in the archives here on how to weld it up and grind it to size. The Opinion of Nebraska Cowman is on target with the rest of the problem. Take out the shifter lever, look inside and use a screwdriver to line up all the slots. If it rolls, it needs the tip fix above. If it is still stuck the forks were not on the gear collars/grooves. Must have the cover off again. Good Luck, I hope it is just in two gears at once at the lever. Jim Nicholson
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|