Cub timimg mark

Posted by Phillip Womble on April 24, 2005 at 12:34:08 from (24.170.150.121):

I replaced the ignition drive oil seal in my 1948 Cub. Before removing the magneto and governor we placed #1 piston at TDC on the compression stroke. Found the timing mark on the governor drive gear, but cannot locate the one timing mark on the idler gear. Finally rotated the crankshaft enough to locate the two marks on the idler gear that mesh with the camshaft, but even with reading glasses and a flashlight I cannot see the single mark that is used to time the governor. Is there any way to properly time the governor without the single mark on the idler?

Follow Ups:

• Re: Cub timimg mark Rudi 08:28:26 04/25/05 (0)
• Re: Cub timimg mark Bigdog 17:03:30 04/24/05 (0)
• Re: Cub timimg mark Bob 13:31:59 04/24/05 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]