Re: Farmall 706 310d sleeves

Posted by El Toro on March 02, 2005 at 05:09:55 from (205.188.117.13):

In Reply to: Farmall 706 310d sleeves posted by Trent R. Young on March 01, 2005 at 22:57:37:

You may need to have a puck made at your local machine shop. Since you have the pistons out they can get a measurement from one of your pistons. The puck should be 1.0" thick from mild steel. The puck should be undercut 1/4 to 3/8"
to .015" less that the sleeve bore and the body
of the puck should be machined enough to clear the
engine block. Drill a 3/4" hole in the center of the puck and use 3/4 all-thread to pull out the sleeves. Hal

Follow Ups:

• Re: Farmall 706 310d sleeves Trent R. Young 12:32:39 03/02/05 (3)
  • Re: Farmall 706 310d sleeves El Toro 14:41:24 03/02/05 (2)
    • Re: Farmall 706 310d sleeves Trent R. Young 17:00:12 03/02/05 (1)
      • Re: Farmall 706 310d sleeves El Toro 12:57:51 03/03/05 (0)

Post a Followup Name: E-Mail: Hide: Yes No Hiding your address protects you from spam generators but allows you to receive email response notifications. Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]