|
Farmall & IHC Tractors Discussion Board |
Re: 'super c ' voltage
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Curt (806 guy) on February 24, 2005 at 18:17:28 from (63.189.49.6):
In Reply to: Re: 'super c ' voltage posted by skippy on February 24, 2005 at 17:36:53:
If it has a 12 volt battery then it probably has been converted to 12 volts already. Does it have an alternator on it? If it does, then its 12 volts for sure. I cannot remember the firing order on that 4 cylinder engine for the life of me, I remember 6 cylinder engines but not 4. The firing order is stamped on one side of the engine somewhere. #1 cylinder is the front of the engine. The dist. cap has #1 stamped on it by the # 1 tower, it may have the rest of the cylinders stamped on it too. Someone can correct me if Im wrong, but I think the distributor rotates counterclockwise, so you put the wires on the cap in the firing order going counterclockwise around the towers on the cap.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
