Re: Clutch Finger Height Question

Posted by captaink on January 04, 2005 at 07:05:31 from (66.115.214.56):

In Reply to: Clutch Finger Height Question posted by Davis D. on January 03, 2005 at 16:30:30:

Been a long time since I adjusted a pressure plate, but if I remember correctly, I used to do them on a flat workbench. The first thing I did was to get the correct distance between the pressure plate surface that contacts the clutch and the surface where it actually bolts to the flywheel. On the B, M, and 560 there are three threaded holes in the piece that presses against the clutch, and corresponding holes in the back plate that bolts to the flywheel. Once that distance is set, then I set the finger distance.

Hope this helps.

Follow Ups:

• Re: Clutch Finger Height Question Bob 07:11:38 01/04/05 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]