|
Farmall & IHC Tractors Discussion Board |
Re: IH 240 U - could I actually have (busted) powe
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave D on December 01, 2004 at 18:03:08 from (4.233.170.88):
In Reply to: Re: IH 240 U - could I actually have (busted) powe posted by deano on December 01, 2004 at 10:28:18:
Deano, thanks for the advice with Coax. Next time I am out in daylight I will look for that plug but it sounds really well hidden. Yes, tie rod ends are also probably past being shot on this unit. I swapped out my 'original' weather-cracked car tires that came with this unit (actually they were old snows) for some more robust 10-ply truck tires about a month ago. Man, I had NO idea this unit had power steering, whether or not it worked! And I didn't even think about that pump under the steering column & gas tank. Thought it went for side implements as there are some hydraulic female outlets on or near it as I recall. I just could never figure out that little whine every now and then as I was rolling along, spinning the wheel like mad. Jeez, I hope it can be brought back to even a little life with more fluid. I would use regular hydraulic oil, right? I do have an I&T manual and will spin up on that. thanks, guys! - Dave
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
65 Massey FERGUSON DIESEL
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|