H tricycle front end question

Posted by haymeadow52 on November 09, 2004 at 19:57:42 from (12.26.62.76):

I'm in the process of reassembling the front bolster after replacing the thrust bearing and oil seal and was wondering what was an acceptable amount of vertical "play" once the castle nut over the sector gear is tightened down. It seems as though the cotter pin will be above the grooves in the castle nut once it is tightened. I may need a washer/spacer above the sector gear to allow the castle nut to remain high enough? P.S. I do have the spacer (under the thrust bearing). Thanks.

Follow Ups:

• Re: H tricycle front end question Andy Martin 05:34:22 11/10/04 (0)
• Re: H tricycle front end question Aces 04:59:26 11/10/04 (0)
• Re: H tricycle front end question Charlie V aka F20II 21:32:49 11/09/04 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]