Farmall & IHC Tractors Discussion Board |
Can I make an axel tube for IH WF?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MM_TX on October 31, 2004 at 19:08:25 from (69.152.249.224):
I found a IH Wide Front late style with tie rods to back off a 400 for $400+$70 freight to go on my M. Before shipping they found axel tube cracked in the back all the way across. They will sell WF now for $300. They have a new IH tube they will send along for $200 no less. What do you think? I can get the pipe & bushings, cut & lay it out & take it to a welding shop to drill & weld. (I don't have a drill press & my welds are not professional) Looks like a bushing welded in the axel for the pivot pin bushing & pin to slide in and 2 bushings welded to the bottom of the tube for the stay rod to fit in. Does anyone know if these bushings are hardened steel or anything special? Or should I just buy the new tube?
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|