Re: 560 disc brakes questions

Posted by CNKS on September 26, 2004 at 11:44:45 from (207.178.99.81):

In Reply to: Re: 560 disc brakes questions posted by Lance R. on September 25, 2004 at 21:44:31:

You can get used housings and actuators from places such as Steel Wheel Ranch or Bates Corp. I don't think new ones are available. Yes, you can have them machined, I just sand mine. Depends on how badly pitted they are, and how much you are going to use them. I would try sanding them, if they don't work well, consider machining. I have done this on two tractors. On one, even with new disks, I have very little adjustment left, so I think they were previously machined to where they can't be machined anymore, or else the new disks were too thin (aftermarket). I will disagree with Hugh (slightly) on the grease. I use a very small amount on the balls, not enough to contaminate the disks, go easy on it.

Follow Ups:

• Re: 560 disc brakes questions Lance R. 18:21:04 09/26/04 (2)
  • Re: 560 disc brakes questions Hugh MacKay 19:36:17 09/26/04 (0)
  • Re: 560 disc brakes questions CNKS 19:35:45 09/26/04 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]