Re: Coil Hot...Farmall 400

Posted by Allan in NE on September 23, 2004 at 16:53:09 from (148.78.243.25):

In Reply to: Re: Coil Hot...Farmall 400 posted by MagMan on September 23, 2004 at 16:37:35:

Jon,

Yes, that is exactly what I mean.

If she is borderline, you let off the starter, the engine is still spinning just a bit, and now all of a sudden we have ignition at the points because we don't have that starter a hoggin' all the juice.

A lot of automotive applications that used points and 12-volt systems would "bypass" that ignition resistor during cranking and feed a full 12 volts to the coil.

If you have ever noticed a GM starter solenoid with the extra little connector lug, this is what it was used for in years gone by. It would jump 12 volts directly to the coil primary circuit.

Same way with the Ford starter relays. Chrysler products grabbed the voltage directly from the starter�s electrical connection block.

No, I'm not good; I'm old. :>)

Hope ya get 'er goin',

Allan

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]