|
Farmall & IHC Tractors Discussion Board |
Re: IH 560 D seems stuck in gear
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RN on September 10, 2004 at 00:05:08 from (166.126.218.245):
In Reply to: Re: IH 560 D seems stuck in gear posted by minnimolineman on September 09, 2004 at 23:04:58:
560 IHC transmissions basicly same as M, 400- old age on shifter can wear enough slop to allow gear to engage or shifter rod end to slip out of sliding fork. second posible is worn shifter fork, third is double gear engagement- locks trans.. Lift top off trans, disengage gears, realign shift fork to engage shift lever, set top back. F20 and M can be accessed trhough belt pulley plate. Might want to braze a little extra metal to bottom of shift rod to reduce slop. Brothers have done this on ACs gear shift levers also. RN
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
