|
Farmall & IHC Tractors Discussion Board |
Re: Farmall M Compression
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Randy in NE on June 17, 2004 at 04:25:41 from (216.58.237.20):
In Reply to: Farmall M Compression posted by Bart on June 17, 2004 at 01:29:44:
The only thing that would cause NO compression would be if all four cylinders lost physical integrity at the same time. This would be like if a valve is stuck open on every cylinder. Or all of the rings broke somehow. Or you have a massive crack in the head or block. I highly doubt any of these scenerios. I would verify the compression tester on another vehicle. Are you getting a good seal around the spark plug hole when you are testing? Are you turning it over several times to make sure you are getting a good test? Even if the camshaft quit turning you are going to get some compression on at least one of the cylinders because you can not physically get a valve open on all 4 cylinders at one time unless something drastic has happened on the top end of the motor.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The 9N Lives Again - by Tyler Neff. I often reminisce about the good old days of my youth when I visited my grandparents on their farm in Moorefield, West Virginia. I lived in Middletown, Maryland, which was about two and a half hrs away from the farm. During my summer vacations I would spend two weeks helping granddad Wilmer with his farming duties. Wilmer and his brother Weldon owned the �Neff� farm. Th
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|