|
Farmall & IHC Tractors Discussion Board |
Re: Stuck M
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by colekicker on May 07, 2004 at 00:35:06 from (128.194.70.143):
In Reply to: Stuck M posted by sccwells on May 06, 2004 at 20:22:11:
How long has she been stuck? The SM I have now was stuck and I put gallons of diesel into the cylinders. Budged just a hair. Worked and worked. Tried to move it by turning the pto with a pipe. Still no good. Had the head off. Cylinders clean. Pulled the pan, oil pump wasn't stuck. Pulled the front cover, not there. I was getting frustrated, it just didn't make sense. Looked from the bottom side of the block, surface rust on the bottom of the middle two cylinders. Knocked the pistons out and honed it, runs like a champ. Just depends on how bad your situation is. Also have an A that was stuck. Dad and I just wanted to see if it'd run, put the old head gasket back on w/ coppercoat. Been running since '97. Some of these old motors are really tough.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Grain Threshing in the Early 40's - by Jerry D. Coleman. How many of you can sit there and say that you have plowed with a mule? Well I would say not many, but maybe a few. This story is about the day my Grandfather Brown (true name) decided along with my parents to purchase a new Ford tractor. It wasn't really new except to us. The year was about 1967 and my father found a good used Ford 601 tractor to use on the farm instead of "Bob", our old mule. Now my grandfather had had this mule since the mid 40's and he was getting some age on him. S
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
