|
Farmall & IHC Tractors Discussion Board |
IH 574
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Brad in VA on March 22, 2004 at 11:42:21 from (198.176.41.2):
I just bought a IH 574 at a auction in Clover VA on sat. Didnt really want it but was bidding and ended up with it. The tractor is a diesel. I had some questions about it. 1) There is a leaver on the right side of the driver down close to the floor that has a sticker around it the shows the tractor going forward and backwards. When it is in the middle the tractor moves when you let out on the clutch. If you pull it backwards it growls and pulls on the motor???? What is this???? 2) Are there any problems with these that need attention??? The guy who had it before didnt like much greese. On the three point anyways. The front looked good though. 3) It has 13.6/36 tires on the rear, from what I can find out it should of had 28" tires on the rear. It was tobacco country down there, is that why??? 4) Does anyone know of a good parts place for them?? I need the battery door and some knobs for the levers, a grill and the schroud around the grill. 5) How do the do in the field??? We do alot of hay and raise cattle. I wanted it for raking and tedding. Will it handle the round baler or does it lack that kind of power (4'x4' bales) 6) This one is hard to get and keep in first. It goes in ok but you have to hold the handle up there untill you let out on the clutch or it will slip out of gear. Any thoughts will be appericated.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|