Farmall & IHC Tractors Discussion Board |
Re: Friction type throttle for M
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Michael Soldan on March 18, 2004 at 14:53:01 from (216.46.130.12):
In Reply to: Friction type throttle for M posted by Ray on March 18, 2004 at 11:47:30:
Ray if you don't find a new throttle plate here are some suggestions. Sometimes adding a washer to the underneath where the throttle handle attaches with the cotter pin will help shim up the throttle, a new spring will help. Also on the wear surfaces you can build up with a bead of weld. the inner end of the throttle handle 90's up against the plate, if it is worn , then the throttle will jump out of the notches and flop back to idle. Run a bead of weld across this surface and grind it smooth, this rejuvenates the throttle handle and keeps it level so it is less likely to jump out of position. You can also take a file and clean the notches up a bit...this doesn't beat replacing with a new plate but I have kept my H working fine with a rainy afternoon "play" with the throttle and its working as new...Mike in Exeter Ontario
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|