Re: Farmall H Lift All Failure

Posted by Haas on November 18, 2003 at 18:40:16 from (12.65.42.158):

In Reply to: Farmall H Lift All Failure posted by Mark in Mi. on November 18, 2003 at 05:27:20:

Get a hydraulic pressure gage and plumb it into your lift line. A cheap gage is only around $15. You should be getting 800 psi if you have a good unit and it should not change much as the oil gets hot. If you are using 30 wt oil and you are not maintaining pressure, then your pump must be worn. The fact that implements hold is good and sounds like you should have a good system. If you are talking about a 3 point hitch, then just change out the cylinder for one same length, but larger diameter and that should take care of it.

Follow Ups:

• Re: Re: Farmall H Lift All Failure Mark in Mi to HAAS 06:01:29 11/19/03 (1)
  • Re: Re: Re: Farmall H Lift All Failure Haas 06:38:58 11/19/03 (0)

Post A Followup Name: E-Mail: Subject: Re: Re: Farmall H Lift All Failure Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]