|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Re: Re: Re: Re: Re: Re: Farmal
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on October 05, 2003 at 16:52:48 from (64.228.12.162):
In Reply to: Re: Re: Re: Re: Re: Re: Re: Re: Re: Re: Farmall Na posted by George Willer on October 05, 2003 at 16:19:56:
George: If you make note I did indicate a figure of 95%, I do conceed wide front was a bit of an advantage and I also understand the pivot point of which you speak. One only has to put a clutch in these tractors to realize how hard that narrow front is to handle. I also think you will agree that narrow front tractors must be properly equiped. I think a narrow front without wheel weights and chloride would be much more vulnerable than the wide front without We also must remember those old narrow fronts were built in the days of 36 inch corn rows and in my opinion I wouldn't get on one without the weights and set on 72" centers. Yes, I would be pleased to come to Ohio next summer for your experiment. I also think you should look at the effects of rear wheel weight. I think those figures will surprise our friends as much as difference between nf and wf. I must admit I had some anxious moments after my post. I thought what if George takes me up on this. We are both over 60, I know my reflexes aren't what they used to be, the last time I was on the 300. Again, yes I would be pleased to join you and yes I think the results of making all tractors safer should be made public. There are a lot of narrow fronts around this old iron hobby, lets equip them as safely as possible.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Torque Wrenches - by Curtis Von Fange. When working with fasteners a torque wrench can play an important role in the correct assembly of critical equipment components. Lets examine in detail some of the reasons for using a torque wrench along with how to correctly use the variety of wrenches available. Applying the proper torque to a fastener accomplishes a number of tasks. First of all correct torque will hold the parts together. This may seem like a trite statement but � think about it for a second. Engineers have designed
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
