Re: Super A Timing Question

Posted by CNKS on August 10, 2003 at 18:04:31 from (207.178.96.212):

In Reply to: Super A Timing Question posted by scotty on August 10, 2003 at 14:10:29:

Gene may well be correct, as he almost always is. But, you point the rotor to #1 before the coupling trips, it may be slighly past afterwards, perhaps not as far as yours is. Install the mag with the top against the block after you have set #1 on TDC, make one complete revolution until the timing mark on the flywheel lines up with the mark on the cast piece behind the oil pan. Pull the top of the mag out until the coupling trips. Don't know if you mean you can't find the mark on the flywheel, or if it is misalinged. The mark is hard to see, but it is there.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Super A Timing Question Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]