sheet metal question, exhaust pipe hole

Posted by bill on August 03, 2003 at 06:52:29 from (65.145.104.86):

the exhaust pipe hole on my H is not completely round.

description: there is a cut in the shape of a half cirlce about 2" out from the hole.

there are also two small cuts in it about 1/4" L x 1/8" W.

THEORY: the old muffler was sitting on the top of the sheetmetal and rubbed a hole in it.

QUESTION: should the exhaust hole in the sheetmetall be perfectly round?, or are there supposed to be two notches in it?

should i just weld it up?

thanks for looking, and i apologize for these elementary questions.

Follow Ups:

• Re: sheet metal question, exhaust pipe hole Bob in SE Nebraska 07:17:12 08/03/03 (1)
  • Re: Re: sheet metal question, exhaust pipe hole rustyfarmall 10:16:07 08/03/03 (0)
• Re: sheet metal question, exhaust pipe hole Dave_Id 07:00:31 08/03/03 (1)
  • Re: Re: sheet metal question, exhaust pipe hole bill 16:25:36 08/03/03 (0)

Post A Followup Name: E-Mail: Subject: Re: sheet metal question, exhaust pipe hole Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]