Re: Sleeves in a C113 engine block

Posted by Bill Hires on July 15, 2003 at 14:14:17 from (128.206.228.106):

In Reply to: Sleeves in a C113 engine block posted by David Bean on July 15, 2003 at 09:42:45:

I do not understand the use of the term "bore", these are wet sleeves and are simple to pull and replace. The Super "C" sleeves will fit into a regular "C" and this is a common practice.The Super "C" is 122.7 cid with a 3.125" bore, the "C" has a 3" bore. You should not have to bore out the engine block counterbores to replace these sleeves. The dry sleeves should drop into place without being forced, remove them and then install the "O" rings in their grooves using a soap solution on the lower sleeve for lubrication, then replace the sleeve, this should not require much force.

Follow Ups:

• Re: Re: Sleeves in a C113 engine block Wrong 20:12:07 07/15/03 (3)
  • Re: Re: Re: Sleeves in a C113 engine block Bill Hires 05:25:16 07/16/03 (1)
    • Re: Re: Re: Re: Sleeves in a C113 engine block Stan(VA). 12:48:18 07/16/03 (0)
  • Re: Re: Re: Sleeves in a C113 engine block Stan(VA). 20:29:38 07/15/03 (0)

Post A Followup Name: E-Mail: Subject: Re: Re: Sleeves in a C113 engine block Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]