Farmall & IHC Tractors Discussion Board |
Re: problems with clutch adjustment on Farmall A
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gene b on May 24, 2003 at 04:31:32 from (67.251.189.4):
In Reply to: problems with clutch adjustment on Farmall A posted by Terry on May 23, 2003 at 22:12:34:
I will bet a dollar to a doughnut that the pilot bearing in the crankcase is dry as the ARIZONA desert. In the past 10 yrs i have probably had a dozen or so of these split and same thing all are dry. I like to use neversieze on the input shaft when going back together as never have the spinning gear problem. This is an ongoing happening with them. Just push in the clutch wait a little and go while you are waiting with the clutch depressed just think of how much fun your 50yr old machine is to operate.
Follow Ups:
Home
| Forums
Today's Featured Article -
Updatin The Charging System of Your Older Tractor - by Tyler Woods. Older tractors have externally regulated generators or externally regulated alternators, in some instances. That means there is one device that turns energy from the fan belt into electrical energy,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|