|
Farmall & IHC Tractors Discussion Board |
Re: Timing my BN
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ScottyNY on May 19, 2003 at 17:25:14 from (162.40.180.197):
In Reply to: Timing my BN posted by Rodger Wells on May 19, 2003 at 16:00:03:
Not to state the obvious, but did you put your finger in the spark plug hole to make sure it was on the compression stroke? Looking won't tell you anything. Is the mag good? Has the front end of the engine been torn down--i.e., if not put back together correctly, the mag drive gear could be out of time? You might try the archives, too, if you don't get any other suggestions. Good luck!
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Mud Daubers and the Old John Deere - by Jon Zehnder. I have a 1941, John Deere Model A tractor I have owned for about a year and a half. This is my first (in case my wife reads this, "FIRST") tractor and it has been a learning experience. After considerable advise and assistance from local tractor nuts and the forums of Yesterday�s Tractors, I had finally got it running pretty well. I have tuned it up, overhauled the carburetor, installed a borrowed, rebuilt magneto, installed a new Power-Trol, patched the radiator, installed new front wheels a
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|