|
Farmall & IHC Tractors Discussion Board |
Re: Converting an Oil Bath Filter to a Paper Filter.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Randy in NE on May 13, 2003 at 05:39:07 from (216.58.237.20):
In Reply to: Converting an Oil Bath Filter to a Paper Filter. posted by Fred KS on May 10, 2003 at 07:35:37:
I'm sure there are pros and cons to both types of filters. Keep in mind that when these old tractors were built we didn't have the technology to make paper filters as efficient as they make them today. Also the size of the oil bath would be monsterous on the new tractors. My C with 113 cu in would use 180,000 cu. in of air per minute at 1600 rpm. A 436 cu in engine at 2600 rpm would use 1, 133,500 cu. in of air per minute or 6.3 times as much air. It would take quite a large oil bath to handle this. Just something to think about.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Horsepower Defined - by Staff. Indicated Horsepower This represents the power developed in the enine cylinder as obtained from the pressure in the cylinders. This is pressure obtained from an indicator which shows cylinder pressures. Indicated horsepower does not represent the actual useful power delivered by the engine. Brake Horsepower This is the actual horse power delivered by the engine to the shaft. It is equal to the "indicated horsepower" less the friction of the engine. It is useful hor
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|