|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: how hot is a 400 engine supposed to get
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dr.Evil on April 23, 2003 at 10:55:08 from (12.4.181.2):
In Reply to: Re: Re: how hot is a 400 engine supposed to get posted by joe on April 22, 2003 at 19:38:00:
According to the manual that arrow is the operating temp for when kerosene, distilate, or "Tractor Fuel" is used. Manual is pretty clear that the top end of the COLD or low end of the RUN range is operating temp on gasoline. I've spent My share of hours on M, M-TA, 450, etc....back when they were newer. In Our clay hills with the 450 I'd pull the T/A back at 1000 RPM and as soon as the needle touched 1450 again the T/A went forward.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Upgrading an Oliver Super 55 Electrical System - by Dennis Hawkins. My old Oliver Super 55 has been just sitting and rusting for several years now. I really hate to see a good tractor being treated that way, but not being able to start it without a 30 minute point filing ritual every time contributed to its demise. If it would just start when I turn the key, then I would use it more often. In addition to a bad case of old age, most of the tractor's original electrical system was simply too unreliable to keep. The main focus of this page is to show how I upgr
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|