Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: C hyd
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Randy in NE on March 31, 2003 at 05:10:07 from (216.58.237.20):
In Reply to: Re: Re: Re: C hyd posted by Brian Schmidt on March 29, 2003 at 18:33:05:
I have a 1950 C that I hooked up a remote two-way valve to. I tapped into the the supply/return lines at the touch control unit. My touch control bypasses internally once the rock shafts reach the desire postion as determined by the touch control lever position. To counter this I run a length of chain between the rock shaft arm and a bolt in the side of the frame. This keeps high pressure going to the two-way valve at all times. I had to put a shut-off valve in the one of the lines to the two-way valve so that I would have pressure to the touch control rock shaft when I wanted to use that. I mounted an external 2 1/2 gallon tank for additional fluid capacity. I am able to lift a hoist on an old grain wagon. Doesn't lift it fast but it will lift it.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|