|
Farmall & IHC Tractors Discussion Board |
12V conversion problem/question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by LanceM on February 20, 2003 at 16:20:59 from (216.241.128.86):
Hi,
Converted my A to 12V using the directions on this site, very good directions I might add, anyway with the switch off the altenator is still drawing around 300ma, something I found out after the A sat for a couple of weeks with out running and when I needed it the battery was dead. The question is do I have a bad alt? and I'm thinking of fixing the problem by switching the wire that goes to term 1 so in the off position it is open also like term 2. Would there be a problem with doing this? Otherwise it charges great and has worked out to be a very inexpensive conversion for me, just what I needed right now on my work tractor. Looking forward to some answers/opinions, Lance
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Maintaining Rubber Tires - by Staff. The broad use of rubber tires on farm tractors and machinery has resulted in a great saving in both time and operating costs since the time of steel wheels. There are, however, certain basic fundamentals in the care of tires that should be followed carefully if the owner is to derive maximum benefit from his or her investment. First and most important is to maintain proper pressure for the work at hand. Your best guide to proper inflation is the operator's manual or instruction book tha
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
