|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Need help fine tuning carb. on a 47 Super A (Zenith)
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by CNKS on February 19, 2003 at 12:27:44 from (207.178.96.214):
In Reply to: Re: Re: Re: Re: Need help fine tuning carb. on a 47 Super A (Zenith) posted by Greg on February 19, 2003 at 05:47:21:
The idle mixture is adjusted when the tractor is idling at MINIMUM RPM. Yes the T handle screws the needle into the main jet. Wish all the A B C carbs were that way but they're not. The main jet's T handle is adjusted at wide open throttle. As to the direction to turn the idle mixture screw, I will quote from the service manual -- (you need to get one, and a parts and a operators manual):"Turning the idle adjusting needle TOWARDS the seat increases the suction on the idle jet, and, hence more fuel flows through the calibration --- Turning the idle adjusting needle AWAY from the seat reduces the suction on the idle jet and as a result less fuel flows through the idle jet. This is a very simple carb, perhaps your mechanic did not clean it out well enough, or didn't replace some needed part.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Perfect Restoration - by Chris Pratt. Often, in quiet moments, I have wandered back in my thouhts to the many tractors I have seen over the years and wondered which one inspired me the most. Sure, we have a fond attachment to one brand and model or another, sometimes it was remembering that first time we got to climb up in the drivers seat and command that roaring beast, or maybe because when you see that special model, you can't help but see Dad on it, he's gone, but everytime you see a tractor like his, it's a like part of him i
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
