|
Farmall & IHC Tractors Discussion Board |
Re: Super WD9 Gas Starting Problems - HELP NEEDED PLEASE
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Richard on February 18, 2003 at 11:42:02 from (205.188.209.78):
In Reply to: Super WD9 Gas Starting Problems - HELP NEEDED PLEASE posted by Clark Weaver on February 18, 2003 at 09:04:59:
Take the valve cover off,then move the compression lever back and forth. watch the rod that pushes the starting valves down. if they are not going down you need to adjust the lever. carb kits are $275. at bates.corp.com float and gaskests. Just because the float is moving doesn't mean its getting fuel. One more thing it could be is the butterfly valves in the intake manifold which work on trip lever when compression lever is moved.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Converting from 6 Volt to 12 Volt - by Chris Pratt. It's a common problem for old machines especially when the weather starts to dip below 40 and the tractor isn't fired up as often. You are probably used to the 12 volt Diehard, charged with 200 amp alternator of your 3/4 ton that always is ready and always starts. It's this type of experience that brings about the many queries we get for 12-volt conversion kits. Since only a few kits are available (we sell kits for the
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
