|
Farmall & IHC Tractors Discussion Board |
Re: IH Distributor question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by dan on February 16, 2003 at 15:55:40 from (66.230.21.209):
In Reply to: IH Distributor question posted by Daniel on February 16, 2003 at 15:06:47:
I had that same problem on my super c and some others at work. I may be wrong and someone will speak up if I am but I think someone had that bushing made and the machinist for some dumb reason didn't drill it out. Most new distributers I have seen and almost all of the old ones on letter series tractors didn't have a bushing. it was just steel to steel. That is why the grease fitting which was originaly a plug that you were supposed to take out once a year and install a zirc to grease it then put the plug back in. I think I read that in a cub owners manual. When I rebuilt my distributer I made a bushing and I did drill a 1/8 hole for the grease on both sides and I just leave the grease fitting in it. It only needs it once a year or so. The one that is on the gear end of the dist. needs it a lot more and I think should be packed not just a couple sguirts. That is just my opinion. I have seen a lot of those gears ruined from not enough lubrication. If you are replacing your shaft make sure you can not wiggle it at all. there should only be 1 to 3 thousandths clearance. any more and you will get points that can never be set properly and it won't run just right. if it does wiggle then you can either take it to a machinist to make another bushing or replace the dist. body. I am pretty sure they are still available. There is also a small felt piece in the end of the shaft for oiling the advance mechanism just in case yours is missing and you didn't know. they usualy are missing. Let me know if you got any questions as you go I will do my best to help.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Pop's Tractor of Gold - by Gary Teate. My father was a simple man but could repair just about anythin mechanical that was ever made. From the time I was a young boy growing up in Jacksonville, Florida, I would spend a considerable amount of time helping my father repair or rebuild equipment and engines, etc. on our 2 1/2 acre "spread". Pop always dreamed of having more acreage out in the country where he could retire and tinker as much as he wanted and often reminisced about his boyhood days on his grandfathers farm in Montecello,
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|