Farmall & IHC Tractors Discussion Board |
Blue smoke after engine work....
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Doug in NJ on February 13, 2003 at 12:39:54 from (67.81.52.249):
Just finished replacing the O-rings and piston rings in my 1946 Farmall A. Sleeves were not replaced, but were honed. Original pistons were re-installed with new rings pickled pretty good in oil. When I started her up, she smoked blue as expected, but after running for about 4 minutes, she still smokes heavily. I expected the smoke to disappear after about 2 minutes. Could it be that the new piston rings may take longer than I expect to seat properly in the honed sleeves? Could it be that the pickled oil in the ring slots is still burning off? Or did I do something wrong. Any thoughts???
Follow Ups:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|