|
Farmall & IHC Tractors Discussion Board |
Re: Anyone put a hydraulic pump inline with crankshaft?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by D Webber on January 08, 2003 at 13:51:00 from (216.106.41.59):
In Reply to: Anyone put a hydraulic pump inline with crankshaft? posted by Bob G on January 08, 2003 at 08:54:55:
I have a Super A with an A motor ( before my time ) . When I bought it it had a power steering pump to run the Hydraulics . It was slower than the second coming so I proceded to look into ways of fixing the problem , short of changing a good motor . The crank has a centering hole in it, so I made a shaft that looks like the end of a hand crank . I ground down the end so it fit the centering hole and placed it in there with a small combine pump on the end. I made sure it self centered then tightened it up.That was 2 years ago and it runs the touch control perfectly.
So it can be done , but maybe only on tractors that the crank lines up like it does on the Super A.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Memories of a Farmall C - by Monty Bradley. When I was a child, my grandparents lived on a farm owned by a Mr. Walters. The crops raised were cotton and soybeans, with about forty head of mixed breed cattle. Mr. Walters owned two tractors then. A Farmall 300 on gasoline and a Farmall C, that had once belonged to his father-in-law, and had been converted from gasoline to LP Gas. Many times, as a small boy, I would cross the fence behind the house my grandparents lived in and walk down the turn row to where granddaddy would be cultivati
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
