|
Farmall & IHC Tractors Discussion Board |
Re: Re: M Farmall rear axle gasket
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ROND on December 30, 2002 at 20:02:53 from (67.251.163.45):
In Reply to: Re: M Farmall rear axle gasket posted by Bob in SE Nebraska on December 30, 2002 at 19:15:38:
YOU CAN DO LIKE THE GUYS SAID OR REMOVE THE PTO REACH IN AND REMOVE THE BOLT THAT HOLDS THE BULL GEAR TO THE AXLE,THEN PRY THE HOUSING OFF. THIS IS THE WAY I HAVE DONE WHEN THEY HAVE A MOUNTED CORNPICKER,BE SURE TO SUPPORT THE TRACTOR GOOD.HOPE THIS HELPS. GOOD LUCK !!
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
History of the Nuffield Tractor: Conclusion - by Anthony West. In the last piece I mentioned that Nuffield had reached the stage where they had chosen to drop the "Universal" from production. The two new models were given three figure numbers, instead of "three" and "four". Model numbers were introduced to help farmers and dealers instantly recognize the engine size and horsepower of the tractor, the 4/60 had a four cylinder diesel engine which developed 60 bhp at 2,000 rpm. The 3/42 had a 3 cylinder diesel engine which produced 42 bhp at 2,000 rpm. Th
... [Read Article]
Latest Ad:
1952John Deere MT tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
