Re: Wiring Diagram

Posted by mark on December 15, 2002 at 05:05:35 from (24.59.249.185):

In Reply to: Wiring Diagram posted by Plains Hunter on December 15, 2002 at 04:27:54:

The 40's - 50's letter series farmalls with a 6 volt ground positive system should be wired basically the same.
The ignition switch should have 2 wires.
One Ign switch to coil
Two Ign switch to "L" terminal on the voltage regulator.
From the ammeter neg one wire goes to the starter
From the ammeter pos one wire goes to the "BAT" on the voltage regulator.
One wire from "GEN" on the voltage reg to the "A" terminal on the generator. From the "F" terminal on the generator to the "F" terminal on the voltage regulator.
Positive side of the coil to the side of the distributor.
Negative side of the coil to Ignition switch.
Connect all wires with the pos battery cable (this is your ground) OFF.
When completed connect the ground cable but dont try and start it until you polarize your generator.
Do this by touching a short piece of wire to the "A" on the generator and to the "BAT" on the voltage regulator.
Hope this helps.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Wiring Diagram Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]