|
Farmall & IHC Tractors Discussion Board |
Re: International 1086 - information about TA
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by scottAR on December 07, 2002 at 18:45:37 from (209.194.159.164):
In Reply to: International 1086 - information about TA posted by Thomas Johansen on December 07, 2002 at 04:31:36:
I know a lot of guys on the site will disagree with me but if the tractor was mine I would take the TA out of it and put in the straight shaft. My dad bought a 460 new with TA and it stayed in the shop more than it worked until it went out of warranty. Then years later, I bought a 1566 new with TA and it went to the shop four times in warranty. Then we put the straight shaft in it. When I bought a new 1086 in '78, it was without TA. Put one throwout bearing in it in 8000 hours. My 2 cents!
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
