bearing load adjustment

Posted by Kevin-In on November 27, 2002 at 17:10:53 from (208.143.14.106):

OK guys,
tonight after the four year old goes to sleep going to work on my ten,setting bearing load adjustment on differential and axle bearings.
The book says to tighten to 100 inch lbs,then 50,then 100,check clearance behind bolt heads,get average then add .015 to get shim pack.
My question is,what does 100inch lbs eqaul in foot lbs,I figure a little over 8.
Would anyone agree with that,or is this incorrect.
The axle caps are to be torqued to 150inch lbs too,which comes out to about 12.5 ft lbs,I think.
Would someone know if this right.
Thanks,
Kevin.

Follow Ups:

• Re: bearing load adjustment Gary Glaenzer 17:56:13 11/27/02 (1)
  • Re: Re: bearing load adjustment joe 18:50:57 11/27/02 (0)
• Re: bearing load adjustment Peabody 17:28:03 11/27/02 (0)

Post A Followup Name: E-Mail: Subject: Re: bearing load adjustment Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]