|
Farmall & IHC Tractors Discussion Board |
Re: will an M drawbar fit,,
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Red Rider on November 17, 2002 at 20:16:51 from (65.239.11.156):
In Reply to: will an M drawbar fit,, posted by Bryce Andreasen on November 17, 2002 at 17:31:39:
I have a 400 Diesel that I farm with and pull as well. I use the 2 point to pull from. I did make brackets that bolt to the top of the axles and a bracket on both the 2 point arms. Between these two brackets I use a top link on both sides to make my draw bar stationary for height. As for being able to use an M draw bar without taking the two point off I don't think you will clear the two point hardware. As for the hydratouch control valves, no they only came with one and the other two were optional. Post your E-mail and I will send you some pictures of my two point set up for pulling.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Upgrading an Oliver Super 55 Electrical System - by Dennis Hawkins. My old Oliver Super 55 has been just sitting and rusting for several years now. I really hate to see a good tractor being treated that way, but not being able to start it without a 30 minute point filing ritual every time contributed to its demise. If it would just start when I turn the key, then I would use it more often. In addition to a bad case of old age, most of the tractor's original electrical system was simply too unreliable to keep. The main focus of this page is to show how I upgr
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
