|
Farmall & IHC Tractors Discussion Board |
Re: Farmall M Stuck in high gear
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmer Bob on October 27, 2002 at 21:04:18 from (66.152.73.92):
In Reply to: Farmall M Stuck in high gear posted by Craig on October 27, 2002 at 20:37:08:
Craig, Common problem on old Farmalls. Remove the pin that goes throught the shifter tower at the base of the gear shift lever. May have to take out what looks like a small freeze plug on one side and then punch the pin out. Pull the gear shift lever up out of the tower. With a light, look down in the hole and using a large screw driver, aline the shift rails so the large slot is lined up straight across for all three rails. Look at the end of the shift lever. If it is rounded off and worn down, you may need to get it built up some to fit properly into that slot. Stick it back in and put the pin back in through the shifter. You could have a bent shifting fork but most likely its the end of the shifter lever being worn down.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Mud Daubers and the Old John Deere - by Jon Zehnder. I have a 1941, John Deere Model A tractor I have owned for about a year and a half. This is my first (in case my wife reads this, "FIRST") tractor and it has been a learning experience. After considerable advise and assistance from local tractor nuts and the forums of Yesterday�s Tractors, I had finally got it running pretty well. I have tuned it up, overhauled the carburetor, installed a borrowed, rebuilt magneto, installed a new Power-Trol, patched the radiator, installed new front wheels a
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
