Farmall & IHC Tractors Discussion Board |
Got M now got ?'s
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ty on July 02, 2002 at 07:07:13 from (208.137.64.208):
Yesterday I bought a '49 M with narrow front, 12V conv. and hyd. were conv. to the double action. Serial- FBK-193053X1. Motor was completely redone. It has snap!! Tight front wheels so flying down the road is possible. Now it has some rust in the tank so I was going to clean that out with some fluid and put a section of chain in and work it around and get the loose stuff out. That and in 5th gear will slip out and the shifter doesn't engage like all the others. It has a little winding grinding noise. I had a H that did the same thing but not as often or with the noise.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|