|
Farmall & IHC Tractors Discussion Board |
Farmall 706 PTO won't rotate under a load
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JH on June 27, 2002 at 11:39:20 from (198.26.125.13):
I was using a 7' cutter in the field and after about 3 hours of work, I got off to clean out the front grill screen. When I started up the PTO again it didn't want to rotate. I checked the fluid level and it was up. The remotes for the hydraulics work just fine. The power steering works okay, but not as good as it used to and now it squeals until the tractor is warmed up and doesn't like to be placed at maximum turn in either direction. The 3pt raises and lowers with no problem. When I disconnect the driveshaft from the PTO, the PTO will spin, and the driveshaft on the cutter will rotate freely. So I hooked the driveshaft back up and engaged the PTO again. As long as the cutter is raised up it rotates the cutter driveshaft, but starts out real slow, then slows to a stop when the cutter is lowered. After several attempts to operate, the PTO handle broke off in my hand at one of the bends. I replaced the handle, but my problem didn't go away. I'm going to change the fluid and the filter next just for grins, but what if that is not the problem? Hope to hear from the pros. Thanks in advance.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|