|
Farmall & IHC Tractors Discussion Board |
M Remote Hydraulics
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Doc on June 08, 2002 at 15:06:55 from (204.73.55.90):
I put a factory remote control valve on my M. Same as what came on the Super's and SMTA. I bought this as NOS, valve only. I think I may have it hooked into the system improperly. I ran the pressure hose from a belly pump outlet to the port on the left side of the valve (when looking from the rear), and the outlets to the rear of the tractor from the two ports which are next to each other on the rear of the valve. Problem is with the valve hooked into the system, I get no lift for the loader hooked into the belly pump outlets unless I pull the belly pump lever back and then move the control lever for the remote. This will then lift the loader which is attached to the belly pump outlets. The loader will lift when the remote valve lever is moved in either direction. The loader will not hold up no matter what position either lever is in. I have the IH manual for this valve, does not show which port the different hoses go to. Does someone have one and could give me advice on what goes where? Thanks. Doc
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Horsepower Defined - by Staff. Indicated Horsepower This represents the power developed in the enine cylinder as obtained from the pressure in the cylinders. This is pressure obtained from an indicator which shows cylinder pressures. Indicated horsepower does not represent the actual useful power delivered by the engine. Brake Horsepower This is the actual horse power delivered by the engine to the shaft. It is equal to the "indicated horsepower" less the friction of the engine. It is useful hor
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
