Farmall & IHC Tractors Discussion Board |
Re: Re: 574 BRAKES:HAVE TO PUMP THEM
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by richard on May 26, 2002 at 16:15:38 from (195.93.34.8):
In Reply to: Re: 574 BRAKES:HAVE TO PUMP THEM posted by JD Humm on May 26, 2002 at 12:41:59:
I have copied the following from the training notes from the service course at I.H. in Doncaster England.PTO eiter FULLY disengaged or FULLY engaged.Engine at 16oo RPM.Plastic hose on bleed nipples both open. Bleed with brakes latched together. do not pump pedals as oil supply will not make up fast enough. Allow pedals to return vry slowly. When one tube is free of air close that bleed screw and continue still both pedals latched together untill second pipe is free of air. Hope this helps.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|