|
Farmall & IHC Tractors Discussion Board |
Small problem, Big consequence
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tex454 on May 24, 2002 at 23:51:08 from (172.130.156.11):
Bought an M Farmall recently, has a leaky seal on the right rear axle housing. I pulled the end plate that holds the seal to have a look (with wheel and everything in place) and noticed what looks like a _crack_ in the axle. It is right where the axle comes out of the end plate (when the end plate is in place)and at first I thought it was a small scratch but then I noticed that it went down into the keyway on the axle. The crack goes not quite half way around and appears to have been there a while. I've had the M about a month and haven't worked it much, certainly nothing so traumatic as to crack an axle. Has anyone else had experience with this problem? Any idea what could cause this? A flaw in the steel perhaps? When I've seen shafts fail from torque they usually have a bit of a spiral where they tear. This crack is straight and parallel with the wheel. Obviously I plan to do something about before it sits down in a field somewhere. Anyone have a spare axle or suggestion where to get one?
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Upgrading an Oliver Super 55 Electrical System - by Dennis Hawkins. My old Oliver Super 55 has been just sitting and rusting for several years now. I really hate to see a good tractor being treated that way, but not being able to start it without a 30 minute point filing ritual every time contributed to its demise. If it would just start when I turn the key, then I would use it more often. In addition to a bad case of old age, most of the tractor's original electrical system was simply too unreliable to keep. The main focus of this page is to show how I upgr
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|