|
Farmall & IHC Tractors Discussion Board |
Re: Re: Farmall 230 axle question: Where does the big brass washer Go?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by drizler on May 24, 2002 at 08:16:14 from (12.23.26.27):
In Reply to: Re: Farmall 230 axle question: Where does the big brass washer Go? posted by RPM on May 24, 2002 at 07:07:27:
I couldn't either but I don't have a parts book but rather a hodge podge cover em all type. The washer sure came off somewhere and has the PN C126223 cast into it. It won't slide on the axle from the outside though it was pretty dirty and tarnished looking more like it was a part of the wheel to axle attachment setup. It sure didn't look clean enough to be inside the case but where else could it go. Anything that BIG simply HAS to go somewhere. I sure wish I could get a lood behind that other axle but I can't without pulling the other axle yadda yadda.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that�s wha
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
