|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Farmall 230 axle question: Where does the big brass washer Go?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Drizler on May 24, 2002 at 16:16:54 from (12.23.26.19):
In Reply to: Re: Re: Re: Farmall 230 axle question: Where does the big brass washer Go? posted by RPM on May 24, 2002 at 13:31:54:
Maby thats good news as this axle isn't coming off again without a fight. So there is nothing that locates that bull gear in place other than the retainer. The progression goes like this right? Cap bolts holding on the retainer, bull gear, cap screws holding on inner retainer ring, bearing, oil seal on the end of the tapered portion of the shaft. The outer bearing slides to location on the outer shaft and locates in the race with no inner seal and is held in place with a paper gasketed cap. AHMEN.
Thanx for the help with this perplexing messs RPM.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that�s wha
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
