Farmall & IHC Tractors Discussion Board |
Re: Couple w30 questions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Will@ont.ca on April 30, 2002 at 02:42:59 from (216.58.67.95):
In Reply to: Couple w30 questions posted by sparky on April 29, 2002 at 19:21:40:
Sparky,the w-30 has 4 1/4 X 5 pistons and there the same as 10-20,f-30,it seem there are more parts available for those tractors than the w-30.The M piston is smaller,as far as pulling the flywheel I haven't had to take one off so I don't know which puller is the best.My buddy has some extra pistons from a motor we took apart to repair a motor I was working on he might sell one.Rice Equipment in PA sells new piston and sleeves but quite expensive $900.for a set of piston/sleeves.I give my friend $50. for a piston.Email me if you want to know more. Will
Follow Ups:
Home
| Forums
Today's Featured Article -
Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|