Farmall & IHC Tractors Discussion Board |
Re: Zenith-Carb problems
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jal-SD on April 25, 2002 at 06:59:08 from (64.68.166.199):
In Reply to: Zenith-Carb problems posted by Cobo on April 24, 2002 at 19:25:31:
Almost sounds like an air leak. Are you sure you have a good seal between the carb & intake? (I ask this 'cause I had a friend who was having the same type of problem-after we investigated, found he'd forgotten to install the gasket-H didn't run worth a d--- w/out it.) Did you accidently mess up the float setting when you took out the needle? If the float is set too low, it may be starving. (My $0.02 worth. jal-SD)
Follow Ups:
Home
| Forums
Today's Featured Article -
Updatin The Charging System of Your Older Tractor - by Tyler Woods. Older tractors have externally regulated generators or externally regulated alternators, in some instances. That means there is one device that turns energy from the fan belt into electrical energy,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|