Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: M Farmall grader
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Lenn on February 17, 2002 at 05:41:32 from (208.171.56.59):
In Reply to: Re: Re: Re: Re: M Farmall grader posted by JDM on February 17, 2002 at 04:55:16:
Jdm thanks,i didn`t think about the width,i better leave it the way it is. The problem here is the splines are worn in the wheel so they continue to wear,if a guy could find like new they probebly would fit tight. I drilled a hole in the head of the bolt and in the wheel hub and safety wired one side. Thanks for the info.
Follow Ups:
Home
| Forums
Today's Featured Article -
Oliver 550 Clutch Overhaul Tips - by Greg Sheppard. I got my 1964 Oliver Model 550 (serial 141-139-519) second-hand and used it for several years before the clutch began to slip. After taking up the pedal linkage several times I saw it was going to take more than that. The engine had been leaking oil at the rear seal and I suspected
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|