Farmall & IHC Tractors Discussion Board |
Re: M and W9 axles
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Red Rider on February 14, 2002 at 20:55:17 from (67.226.44.33):
In Reply to: M and W9 axles posted by Lenn on February 14, 2002 at 15:23:10:
The axles are the same as a W6, And yes the axle from an M or Super M will interchange. The splines on the bull gear end are the same. The outer seal cap is also different and the one off an M or Super M will fit. I don't quit understand your comment about the spline wearing out. I have a 600 Diesel that has the same 6 spline axles only larger and they are so tight that It is very hard to remove the wheel. I had to replace the seals on my 600 and it was a real job getting them off.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|