F-20 Rear Wheel Question

Posted by JohnG(TX) on February 11, 2002 at 20:35:15 from (216.198.62.241):

I think this was answered earlier, but I can not remember the answer or find the post, so here it is again. I believe there was another tractor manufacturer who used the F-20 bolt pattern which would enable the wheels to be interchangable. On my 1936 F-20, I have some flat spoke F&H wheels. They seem to have some yellow paint under the grease on the back. Also, when my grandfather ran the tractor, he or someone else put some shim plates between the wheels and hubs. I am guessing this was to space them out so they would not hit the brake cover, or because the center opening would not fit the raised part on the hub. The rear axle is completely disassembled now, so I can not check this out right now. I have seen lots of round spoke F&H wheels, but not the flat spokes. Are they from another tractor? Any ideas?

Follow Ups:

• Re: F-20 Rear Wheel Question randy hall 20:37:40 02/11/02 (0)

Post A Followup Name: E-Mail: Subject: Re: F-20 Rear Wheel Question Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]