Posted by Janicholson on March 23, 2009 at 19:30:56 from (66.173.50.172):
In Reply to: M Clutch Adjustment posted by Bob Mills on March 23, 2009 at 19:19:06:
The Throw out bearing probably came off of the Fork, or wedged onto it at the tips of the fork. The clutch will be fixable from underneath. It might have Throwout bearing issues, so adjustment might disguise a problem. If it had to be pushed, as you indicate all the way, the freeplay was probably about 1/2 pedal travel. It is about an inch measured at the platform to pedal rest stop, when the pedal is pushed down by hand pressure to the point it begins to get hard to push. Removing the Liftall pump, and looking into the area will show the problem. It could be a bent release fork, or a bad T/O bearing, or just out of adjustment and crooked at the fork tips. JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - More Memories of a Field Service Engineer - by Brian Dye. Introduction: The author worked for one of the largest Ford tractor dealerships in England as a trouble-shooter on tractor engines, hydraulics and combine harvesters from 1963 to 1972. In 1972 he became a dealer manager and finally left the dealer net in 1975 to run his own electronic design and manufacturing company. [Editor] We live right in the middle of Norfolk. The dealership that I worked for sold Fordson Tractors from the 1920's and some of t
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
